首页>叉车租赁>叉车出租新闻

二手叉车怎么维修保养?

2021-03-151462次
一、叉车刹车片
forklift brake pad
叉车刹车片呈现磨损,在正常的叉车驾驭行车中,靠感觉是感觉不出来的。有些能够直接查看,但有些车型需求拆卸出来才干看到。正常的刹车片有9毫米厚,当磨到2-3毫米时就必须换了;等全磨破显露刹车片附着的金属片,这样就会呈现金属与金属冲突的异响。梯诺机械表明替换刹车片时一般修理工都是让一切有相关的叉车配件都一同换掉,正常情况下都是能够单换的,如:只是单刹车分泵漏油,换了刹车分泵后刹车片能够清洗洁净刹车片和刹车轮毂,假如是刹车片磨损的话刹车轮毂没磨损,只换刹车片就能够了,其他配件就清洗洁净,轴承方位再从头增加新的黄油即可,全部安装好后再调 下刹车片和刹车轮毂之间的间隙就能够正常运用了。
the forklift brake pad is worn out, and it can not feel out of the normal forklift driving. some can directly view, but some models need to be disassembled to see. normal brake pads are 9mm thick and must be replaced when worn to 2mm-3mm; when fully worn to expose the metal attached to the brake pads, there will be a metal-to-metal clash. tino machinery shows that when replacing the brake pads, the general repairman is to replace all the relevant forklift parts together, under normal circumstances can be replaced singly, such as: only a single brake sub-pump leakage, replaced brake sub-pump after the brake pads can clean the brake pads and brake wheel hub, if the brake pads wear out the brake wheel the hub is not worn, just change the brake pad can be enough, other accessories on the clean, bearing bearing bearing position from scratch to add new butter can be installed after the adjustment of the brake pad and brake wheel hub clearance can be used properly.
二、叉车火花塞
two. forklift spark plug
叉车火花塞是在修理时有许多的修理商都会劝叉车用户提早替换的小配件,但实践上假如驾驭员在用车时没感觉到有焚烧不良、加速不力、没有放炮等缺点现象的话就能够不替换。可是定时要拆出来查看是有必要的,但假如火花塞确实坏了就一定要及时替换,有些车型坏了的火花塞还会呈现掉落掉在发动机的汽缸里边,这样就会引发更大的叉车缺点。
forklift spark plug is a small part that many repairmen would advise forklift users to replace in advance when repairing, but in practice, if the driver did not feel burning, acceleration, no artillery and other shortcomings when using the truck can not be replaced. but it is necessary to take it out regularly, but if the spark plug does break, it must be replaced in time. some models of broken spark plugs will fall into the engine cylinder, which will lead to greater forklift defects.
三、叉车刹车油
three. forklift brake oil
正常情况下修理工一般要求1年左右即进行替换,但实践没太大缺点,假如叉车制动体系配件未呈现异常就不必替换。但需常常查看有没有短少或许蜕变或许也能够经过目测,假如刹车油低于低液面就真的需求换或许直接增加了。叉车刹车油假如严峻短少会影响到刹车的制动功能,在替换叉车刹车油必须要换正品的,不是正品的用久了后会形成整套刹车体系会失灵。梯诺机械表明关于刹车油是否正品的检测办法能够用以下这个办法:伸个手指进到刹车油瓶内,泡到刹车油后然后伸出来在正常空气中一分钟左右手指有发热的感觉,根本能够判断为这款叉车刹车油为正品。
under normal circumstances, repairmen usually require about a year to replace, but the practice is not too big shortcomings, if the forklift brake system accessories did not show abnormal need not be replaced. but often check to see if there is a short or metamorphosed or can be visually monitored, if the brake oil is below the lowest level, the actual demand for replacement may increase directly. if the brake oil of forklift truck is severely short, it will affect the braking function of the forklift truck. the brake oil must be replaced by the genuine one, and the whole brake system will fail when the genuine one is not used for a long time. tino machinery shows that the test for brake oil can be used to determine whether the brake oil is genuine or not by stretching a finger into the brake oil bottle, soaking it in the brake oil, and then sticking it out in the normal air for about a minute or so. the brake oil can be judged to be genuine.
四、叉车机油
four. forklift oil
一些进口的机油正常情况下是在1500小时进行替换,而国产的机油一般是在750个小时左右就必须要替换。但实践上只需油色明澈、油面不低于标明的低液面,没有特别情况下机油的替换也不必那么频频。运用频频的叉车(一天操作超越十个小时以上)能够一个月左右替换,运用需求一般的叉车(一天操作在正常的八小时内)能够三个月左右保养一次,而运用较少的叉车(一天操作不超越三小时的)主张要半年保养一次,要不会形成发动机容易磨损和润滑欠好的情况,机油必须挑选正品的来运用。
some imported oils are normally replaced in 1500 hours, while domestic oils are usually replaced in about 750 hours. but in practice, only the oil color is clear, the oil level is not lower than the lowest level marked, there is no special case of oil replacement need not be so frequent. frequent forklift trucks (operated more than ten hours a day) can be replaced about a month, with a general demand forklift truck (operated in normal eigh